Whole garment computerized flat knitting machine

ukTo make the (White) Skull tea cosy you will need. At the bottom of each side seam, sew about 3cm upwards. With the front and back right sides together, sew about 9.5mm knitting needles and double thickness white yarn cast on 28 stitches and work 4 rows in straight garter stitch (Knit each row) Then work computerized flat knitting machine 22 rows of Stocking Stitch (one row knit, one row purl) Leave the stitches on a spare needle until later.co.Not even the teapot can escape the Halloween festivities if you make this Halloween Skull tea cosy.

Row 11: *K2 tog* repeat to end. The Skull tea cosy is made from double thickness yarn for extra insulation. The BackUsing size 5.Row 5: *K3, K2 tog* repeat to end. The FrontUsing size 5. Thread the end of the yarn through the remaining stitches and through the loop of the yarn itself and draw up the knitting tightly and Finnish off... Shaping the top Row 1: *K5, K2 tog* repeat to end Next and every alternate row Purl..Row 9: *K1, K2 tog* repeat to end..5 mm, UK size 5 or US size 9 knitting needles,50g White Double knitting wool,25g Black Double knitting wool,And the Skulls face pattern which can be printed off at the link belowDivide the Black and White balls of wool into two balls so that the yarn can be used as double thickness but knitted up as a single strand.This tea cosy was designed by TeaCosyFolk.5mm knitting needles and double thickness white yarn cast on 28 stitches and work 4 rows in straight garter stitch Then work 20 rows from the pattern to create the skulls face.Row 7: *K2, K2 tog* repeat to end.5.Using Red wool as a double yarn proceed to knit across the tea cosy front and then tea cosy back as Follows.. Finish off all the ends inside the tea cosy left over from knitting the face. Row 21: KRow 22: P Shaping the top.. Row 3: *K4, K2 tog* repeat to end. The holes are left for the teapot handle and spout. .5cm from the finishing off point down the side seam towards the cast on edge